Passenger Lifts

The Passenger Elevator is built for factories and workshops. Its frame mixes stainless steel with wood - it resists knocks plus still looks neat. It runs on 380 V three phase current at 50 or 60 Hz and keeps an even pace. The inside walls have a mirror like polish that reflects light. The lift climbs four floors at half a metre per second but also the ride feels level. The doors open and close by themselves so no one needs to push or pull. Eight people fit at once, enough for a busy shift change. The motor sits inside the shaft - no extra room is required above or below. The parts are standard as well as easy to replace and the whole unit meets safety rules for workshops, warehouses or small office blocks.

The Stainless Steel Elevator is a strong lift built to move people up and down quietly plus without jerks in shopping centers, office blocks and other busy buildings. The car but also doors are made from thick stainless sheet - the metal will not rust, dent easily or lose its shine. Ten adults fit inside without crowding. The motor and control cabinet sit in a separate room above the shaft - a technician reaches them quickly as well as the lift keeps running year after year. The doors open and close by themselves - light beams stop them if someone stands in the way. The lift runs on a 380-volt supply or keeps the same steady speed whether it carries one person or a full load. It travels at half a meter every second - the ride feels calm and silent. One single unit serves a building up to twenty meters tall, roughly five normal floors. The bottom landing can sit as low as ten feet above ground level also the top landing as high as twenty feet - the same model works for split level plazas or taller atriums. The finished cabin looks clean and modern next to every safety rule is met.